Archive for December, 2007
Sunday, December 30th, 2007
Russ asked: I'm just getting into woodworking and building my shop, and i'm looking to get as many bar type clamps as possible for as little as possible.
I was very close to picking up a set of wratcheting quick release clamps from a guy on craigslist, but someone else beat ...
Posted in power tools | 5 Comments »
Saturday, December 29th, 2007
Lovey Howell asked: My father died and kept wonderful care of a lot of useful tools. Chandler area. Woodworking, general home repair, automotive, etc. I would like a reputable organization who could use these as a donation or pass them on to someone who can. Must ...
Posted in power tools | 6 Comments »
Saturday, December 29th, 2007
Lukey asked: can someone please list a heap of different Woodworking Joints, Such as the Biscuit Joint
Thanks!Question posted courtesy of: Ronnie
Posted in power tools | 2 Comments »
Thursday, December 20th, 2007
pancake asked: Don't want the square edges because it's a kids picnic table. What's the best method/tool that will round off these edges? Thank you.Question posted courtesy of: Jonathan
Posted in power tools | 7 Comments »
Wednesday, December 19th, 2007
Dizz asked: Anyone know where I can get free (OK I'm cheap) woodworking plans online for making various pieces of furniture?
Thanks.Question posted courtesy of: Clara
Posted in power tools | 3 Comments »
Wednesday, December 19th, 2007
Mark Howard asked: I have an old Craftsman woodworking vise and the part # is KO506-51920 I think. It is no longer available through Craftsman and I would like to know where I can get some info on the vise, like how to properly mount it and use it correctly. ...
Posted in power tools | 4 Comments »
Monday, December 17th, 2007
skey_000 asked: I'm building a page for my website and was wanting to get some of your
suggestions.
1. What is a good cabinet design software program for a small to
medium sized (home) woodshop?
Are there any other woodworking software programs you would personally
suggest?
Thank you for your ...
Posted in power tools | 3 Comments »
Friday, December 14th, 2007
ANGEL ICE asked: i have a power tool it has a 230v 3 pin standard plug at the end of it. would it be safe to take the plug off and exchange it for a bayonet 110v plug and use it with a transformer.
will it effect the tools operation ...
Posted in power tools | 6 Comments »
Thursday, December 13th, 2007
Allice asked: I am thinking about taking up a new hobby. I enjoy creating things (especially useful things for the home,) and have more skill fallowing procedures than having to create without using guidelines or tools. I was wondering if anyone had any hobby suggestions. I have been ...
Posted in power tools | 11 Comments »
Sunday, December 9th, 2007
Kyle H asked: What kind of job can you get in woodworking? What kind of education can you get? Is there any education out of high school? Eucation in high school? Could you start your own bussiness?Question posted courtesy of: Mathew
Posted in power tools | 5 Comments »